Posted: Fri Oct 05, 2007 9:14
Installed a few things today on my day off. There's a guy on mazdas247.com producing lightweight accessory pullies for 2.0L Proteges. He started with the alternator pulley and is working on the water pump pulley and power steering pulley.
.JPG)
.JPG)
.JPG)
The lightweight pulley is something like 100 grams lighter. Not a huge amount, but since it's spinning, it's just that much more crucial.
And I got the GT Spec 4 point ladder brace installed. Yes, normally GT Spec stuff is orange, or more recently blue, but the guy who I bought this from (same guy who is doing the pullies as a matter of fact) powder coated it black.
this is the stock brace- it probably does the job fine but weighs about 3 or 4 times as much as the GT Spec piece.
.JPG)
.JPG)
.JPG)
.JPG)
Plus I readjusted my Racing Beat cat-back. When I installed it originally, the muffler tip sat too close to the rear bumper cover and would rattle at times- like ALOT! Now it looks like it's nice and clear.
The lightweight pulley is something like 100 grams lighter. Not a huge amount, but since it's spinning, it's just that much more crucial.
And I got the GT Spec 4 point ladder brace installed. Yes, normally GT Spec stuff is orange, or more recently blue, but the guy who I bought this from (same guy who is doing the pullies as a matter of fact) powder coated it black.
this is the stock brace- it probably does the job fine but weighs about 3 or 4 times as much as the GT Spec piece.
Plus I readjusted my Racing Beat cat-back. When I installed it originally, the muffler tip sat too close to the rear bumper cover and would rattle at times- like ALOT! Now it looks like it's nice and clear.