Hey if anyone is interested (2.0L / 2.5L 2nd gen / 2.0L Skyactiv / 1rst / 2nd gen speed 3 )

For anyone who is interested who would like to get tuned I'm going to be setting up a Dyno - day at UPP where I may be able to get some discounted dyno rates depending on how many cars we can get.
I will also be in las vegas for tuning next month, and possibly some tuning in texas later this year.

N/A- Mazda 3's will be tuned on MazdaEdit software
Speeds on ATR.


Here is a Speed I just did ( got close but ran out of dyno time )

Do you work at/tune for UPP or just use their dyno for tuning?

I don't need a tune but I would be down to come hang out with some fellow mazda junkies depending on the day.

D Walker wrote:I have used Dynotronics services for the Ecutek in the World Challenge MX-5 and DO NOT recommend them, at all. For ECUTEK tuning please feel free to PM me and I will provide a competent tuner who tunes my race car since we decided not to purchase the ECUTEK MASTER license and cannot tune it myself. The guys at UPP (CK) are good guys but again, WILL NOT use Dynotronics for anything in the future.

Sorry you had a problem, but I do not do the ECUTek tuning, I do MazdaEdit tuning, and I also do the tuning solo, privately and as of right now I have discontinued tuning for the time being, for personal reasons. I also don't tune the MX-5.

What problems did you have with the ECUTek on the MX-5?

If you end up getting a dyno day planned, I'd be interested is seeing what my stock RX-7 GSL-SE puts down. most say around 110 at the wheels.

RX-7 Chris wrote:If you end up getting a dyno day planned, I'd be interested is seeing what my stock RX-7 GSL-SE puts down. most say around 110 at the wheels.

if you guys can figure out a day that works best for you I can probably make it happen

D Walker wrote:Then you should not have put it into your original post then edited it out. You stated that you tune with ECUTEK and were proud to have Dynotronics as a partner, then you edited that part out, you should have just left it in.

first off, no.


Show me where I said I tune with ECUTek? I NEVER said I tune with ECUTek, and it was NEVER edited out. Quite apparent you're just making stuff up at this point because I NEVER said ANYTHING about ECUTek, neither did I say about a "partnership" I merely said I was working for.

I also NEVER said UPP was a part of this, I merely said I can use their dyno to tune you, like ANY shop... Pretty clearly failed to read that.

I only edited out the "dynotronics" part of my post because it caused unnecessary problems that has nothing to do with me. Which I apologize for anyone reading this and has to deal with the issue D Walker is having.


I'm sure a Moderator can easily pull up my post before it was edited, and see that ECUTek has not once been mentioned

I did just check the old post and ECUTek was not mentioned.