(Crappy) dyno pull of R12:

[ame="http://www.youtube.com/watch?v=qWtP6f4gYT4"]RPI Formula SAE R12 on the Dyno - YouTube[/ame]

So this is a rather old thread, but we had roll out for our new vehicle last night. Here's the link to all the photos, and some to post up in the thread:









Bonus: Here's the Elise that a team alum from the class of 2009 owns.

https://www.facebook.com/media/set/?set=a.487171111331672.1073741826.186662521382534&type=3

Notes:
The car isn't actually done and will be different from what it looks like there. There's going to be a diffuser added to the rear (it was on display at the aero table upstairs for the event), and there are two more sections of the rear wing to be put on in addition to the front canards. Not to mention all the sponsor stickers that will be going on the car.
There's plenty left to be done too. The suspension isn't fully finished and as such the car wasn't sitting on the suspension last night. The steering rack needs to be remade as I was told by the person that designed it (just have the part remade, not redesigned). The engine doesn't run yet and the wiring has barely begun to get done. Those are just a few of many things left to get finished.