AEM 52mm Electronic Boost gauge
Posted: Wed Mar 16, 2011 9:14
Putting this up for sale to CMZC members first, then everywhere else.
I'm selling my AEM 52mm electronic boost gauge. Gauge is in 100% functioning shape and works as advertised. Reads up to 35psi and 30 inHG of vacuum. The sensor also self-calibrates to our altitude.
Backlighting changes to 7 different colors (currently set to red) including red, green, blue, purple, orange, white, and aqua. Gauge also utilizes a 0-5v analog output to connect to any linear 0-5v input on a datalogger or EMS, for example.
One issue with the gauge, which is clear in the following pictures, is there is a small piece broken off the back. When installed in a pod, gauge cup, or something similar, this is in no way visible. It does not effect the electrical connectors at all, either. I stupidly broke this when attempting to remove one of the mounting studs off the rear, had the stud half way cut and got impatient and grabbed it my pliers assuming the weakened stud would snap off. Wrong, the plastic it was molded into broke!
Once again, this is NO WAY effects the operation or look (installed) of the gauge!
This includes everything- obviously the gauge, power harness (has been shortened and wrapped in electrical tape, but is still roughly 3ft long) sensor haress (uncut and 100% in-tact), boost sensor, and even the original box with instructions, butt crimps and AEM sticker!
MSRP Retail is $175, I am letting this go to CMZC members for $100 bucks. I am willing to meet anyone within reasonable distance as well!
Pictures:
Broken back panel:
You can see the electrical connectors are 100% in-tact and fine:
Everything included as if you bought it new!
Thanks!
-Dave
I'm selling my AEM 52mm electronic boost gauge. Gauge is in 100% functioning shape and works as advertised. Reads up to 35psi and 30 inHG of vacuum. The sensor also self-calibrates to our altitude.
Backlighting changes to 7 different colors (currently set to red) including red, green, blue, purple, orange, white, and aqua. Gauge also utilizes a 0-5v analog output to connect to any linear 0-5v input on a datalogger or EMS, for example.
One issue with the gauge, which is clear in the following pictures, is there is a small piece broken off the back. When installed in a pod, gauge cup, or something similar, this is in no way visible. It does not effect the electrical connectors at all, either. I stupidly broke this when attempting to remove one of the mounting studs off the rear, had the stud half way cut and got impatient and grabbed it my pliers assuming the weakened stud would snap off. Wrong, the plastic it was molded into broke!
Once again, this is NO WAY effects the operation or look (installed) of the gauge!
This includes everything- obviously the gauge, power harness (has been shortened and wrapped in electrical tape, but is still roughly 3ft long) sensor haress (uncut and 100% in-tact), boost sensor, and even the original box with instructions, butt crimps and AEM sticker!
MSRP Retail is $175, I am letting this go to CMZC members for $100 bucks. I am willing to meet anyone within reasonable distance as well!
Pictures:
Broken back panel:
You can see the electrical connectors are 100% in-tact and fine:
Everything included as if you bought it new!
Thanks!
-Dave
